Supported rail with a shaft diameter of 20 mm in the execution TBS
. (The camp shown is not included and must be ordered separately!) Span>
Technical data:
shaft diameter: 20mm
length: 300 mm (L)
width of the substructure: 55mm (B)
fixing hole spacing: 40mm (C)
distance mounting surface wave center: 29mm (h)
thickness of the substructure: 8mm (T)
distances of the fixing holes: 150mm (P)
weight: 4,23kg / m
material of the base aluminum
material of shafts: GCr15 high carbon chromium steel
hardness: HRC62 +/- 2
roughness: Ra0.8
straightness: better 50 microns / 300mm
tolerance: g6
SBS or TBS?
The SBS and TBS rails differ only minimally in the dimensions of the aluminum substructure.
The essential difference is the width of the base. SBS rails narrower than TBS rails. The heights also differ by a few millimeters. TBR stock and SBR bearings can be both combined with TBS Supported Rails than with SBS Supported Rails.
The right linear bearing:
- TBR20UU li>
- SBR20UU li> < li> SBR20LUU li>
- LME20UUOP li>
- LM20UUOP
ul> li > ul>
cutting:
The linear guides can be shortened surcharge to your desired length
you get exactly tailored tours with squared rectified edges.. The shafts are slightly chamfered so that the seals of the linear bearings remain intact during installation. We
We'll make you an offer! Write to usinfo@dold-mechatronik.de.
Product safety information
Manufacturer information:
DOLD Mechatronik GmbH
Schleifmattstr. 2
Baden-Württemberg
Haslach, Deutschland, 77716
info@dold-mechatronik.de
https://www.dold-mechatronik.de
Responsible person:
DOLD Mechatronik GmbH
Schleifmattstr. 2
Baden-Württemberg
Haslach, Deutschland, 77716
info@dold-mechatronik.de
https://www.dold-mechatronik.de
There are no reviews yet.
