Supported rail with a shaft diameter of 16mm in the execution TBS
. (The camp shown is not included and must be ordered separately!) Span>
Technical data:
shaft diameter: 16mm
length: 1000 mm (L)
width of the base: 50 mm (B)
fixing hole spacing: 37mm (C)
distance mounting surface wave center: 22mm (h)
thickness of the substructure: 6mm (T)
distances of the fixing holes: 150mm (P)
weight: 2,66kg / m
material of the base aluminum
material of shafts: GCr15 high carbon chromium steel
hardness: HRC62 +/- 2
roughness: Ra0.8
straightness: better 50 microns / 300mm
tolerance: g6
SBS or TBS?
The SBS and TBS rails differ only minimally in the dimensions of the aluminum substructure.
The essential difference is the width of the base. SBS rails narrower than TBS rails. The heights also differ by a few millimeters. TBR stock and SBR bearings can be both combined with TBS Supported Rails than with SBS Supported Rails
The right linear bearing.
- TBR16UU li>
- SBR16UU li>
- SBR16LUU li>
- LME16UUOP li>
- LM16UUOP
Crop
The linear guides can be shortened surcharge to your desired length
you get exactly tailored tours with squared rectified edges.. The shafts are slightly chamfered so that the seals of the linear bearings remain intact during installation. We
We'll make you an offer! Write to usinfo@dold-mechatronik.de.
