Extruder Upgrade Kit for Raise3D SingleDirect
Bondtech upgrade extruder Raise3D SingleDirect with single nozzle.
This extruder upgrade kit for the Raise3D N1/N2/N2+ printer will replace the original feeder placed on the printhead.
It fit´s both dual and single nozzle printers.
E-step value: 415 step/mm
Weight: 252g with the included motors
Included:
- Pancake Stepper Motors
High Performance Extruder
This kit provides a high-performance material feeding system with the ability to print faster with improved quality. The adjustable thumbscrew allows you to fine-tune the force acting on the filament. The kit comes with it own lightweight pancake motor.
The housing parts are professionally SLS printed in polyamide for maximum strength and precision.
ATTENTION!
On early printers an adapter cable is needed in order to connect the factory cable to the new motor. You can determine if your printer has legacy motors with an easy visual check. Motors that require an adapter will have a silver appearance (unpainted aluminum finish) on the front and rear side of the motor. You find the adapter needed at the bottom of this page. If the motors on your printer have a black front and rear motor endplate then you won’t need the adapter.
Reliable Filament Extrusion
It allows for a more reliable printing with all sorts of filaments, both stiff and flexibles and the DualDrive system ensures that the extruder never looses grip of the filament so grinding, slipping is a thing of the past.
Half Weight For Improved Quality And Speed
Original extruder setup on Raise3D is 532g for single setup, this new upgrade is 252g with the included motor and it allows for faster printing without surface issues due to vibration during accelerations/deaccelerations.
Additional Information
The extruder is equipped with a push-fit connector for 4 mm PTFE tube that will let you connect the existing guide tube to the extruder. Tube is not included.
This upgrade fits both the Revision 1 (casted) and Revision 2(cnc-milled) version of the printhead.
Plug & Play solution, no need to cut and solder wires.
IMPORTANT!
It has come to our knowledge that if the ribbon cable to the break-out board gets unplugged when the printer is turned on, thermal runway might happen, make sure that the ribbon cable is securely held in place with hot glue or a zip tie.
Installation Information:
Installs in about an one hour with standard tools available.
Tools you will need:
- 2.0mm Hex Key
- 2.5mm Hex Key
- 3.0mm Hex Key
- Hobby Knife (Box Cutter or X-acto Knife )
- Pliers
Documentation:
- Datasheet
- Installation Guide
About the ThumbScrews:
The Bondtech Raise3D SingleDirect extruder has 1 thumbscrew. It serves to adjust the pressure the floating drive gear makes on the filament.
Tighten it all the way in and then untighten 1 to 2 turns when using hard filament. Or tighten it all the way in and then untighten 3 to 4 turns when using soft filament (flexible).