Extruder Upgrade Kit for Raise3D DualDirect
Bondtech upgrade extruder for RAISE3D DualDirect with dual nozzle.
This extruder upgrade kit for the Raise3D N1/N2/N2+ printer will replace the original feeder placed on the printhead.
E-step value: 415 step/mm
Weight: 425g with the included motors
Included:
- Pancake Stepper Motors
- Two push-fit connectors for 4 mm guide tube
High Performance Extruder
This kit provides a high-performance material feeding system with the ability to print faster with improved quality. The adjustable thumbscrew allows you to fine-tune the force acting on the filament. The kit comes with it owns lightweight pancake motors.
The housing parts are professionally SLS printed in polyamide for maximum strength and precision.
Compatibility With Legacy And New Motors
This Upgrade Kit is compatible with the new Raise3D’s black motors. Older ones (silver) require the “Adapter Raise3D Dual” you can find in the “You may need” column, here on the right hand side.
ATTENTION!
On early printers an Adapter Raise3D Dual cable is required to connect the factory cable to the new motor. You can determine if your printer has legacy motors with an easy visual check. Motors that require the adapter will have a silver appearance (unpainted aluminum finish) on the front and rear side of the motor. If the motors on your printer have black front and rear motor endplates you will not need this adapter.
Reliable Filament Extrusion
It allows for a more reliable printing with all sorts of filaments, both stiff and flexibles and the DualDrive system ensures that the extruder never looses grip of the filament so grinding, slipping is a thing of the past.
Half Weight For Improved Quality And Speed
Original extruder setup on Raise3D is 890g for dual setup, this new upgrade is 425g with the included motors and it allows for faster printing without surface issues due to vibration during accelerations/decelerations.
Additional Information
The extruder is equipped with two push-fit connectors for 4 mm guide tube that will let you connect the existing guide tubes to the extruder. Tubes are NOT included.
This upgrade fits both the Revision 1 (casted) and Revision 2(cnc-milled) version of the printhead.
Plug & Play solution, no need to cut and solder wires.
IMPORTANT!
It has come to our knowledge that if the ribbon cable to the break-out board gets unplugged when the printer is turned on, thermal runway might happen, make sure that the ribbon cable is securly held in place with hotmelt or a zip tie.
Installation Information:
Installs in about an one hour with standard tools available.
Tools you will need:
- 2.0mm Hex Key
- 2.5mm Hex Key
- 3.0mm Hex Key
- Hobby Knife (Box Cutter or X-acto Knife )
- Pliers
Documentation:
- Datasheet
- Installation Guide
About the ThumbScrews:
The Bondtech Raise3D DualDirect extruder has 2 thumbscrews. They serve to adjust the pressure each floating drive gear makes on the filament. Tighten them all the way in and then untighten 1 to 2 turns when using hard filament. Or tighten them all the way in and then untighten 3 to 4 turns when using soft filament (flexible).