milling motor Mafell FM 1000/1000 W / 4000 ... 25 000 1 / min - new model, with only 71dB (A) significantly quieter
New model with portal connection - The speed can be either directly on the device or via a 0-10V signal to externally control.
With the FM 1000 MAFELL has developed a further milling motor "made in Germany".
The high quality and thoughtful details make the MAFELL milling motor at the best partner for its performance class.
The speed can be infinitely to any application set.
In addition, the digital electronics with soft start, constant speed under load, idle speed reduction and overload protection features. The labyrinth seal of FM 1000 protects spindle and bearing permanently against the smallest particles, dust and shavings.
The MAFELL milling motors are under stringent quality control in Oberndorf a. N. prepared. Prior to delivery, each milling motor is "adjusted" under laboratory conditions. This increases the service life and the life
The FM 1000 offers highest concentricity of. & Lt; 0.05 mm at 25 mm distance (in the cone & lt; 0.01 mm). Responsible for this extraordinary precision is the delicate tuning of all components and the fact that anchor and stem are made of one piece and balanced.
A special labyrinth seal protects the spindle and bearing permanently against the smallest particles, dust and shavings.
New! -. Optimized fan geometry for significantly lower noise emissions
The engineers Mafell did a great job. They were able to optimize the air flow in the milling motor for noise from 76dB reduced to 71dB.
So far, the unpleasant Lautsärke was with milling motors of this class one of the main arguments for a much more expensive high-frequency spindle to upgrade.
With the Mafell FM-1000 you get a milling motor with a pleasant noise level at an unbeatable price
- Spindles competition = 78 - 82 dB (a)
- Mafell FM-1000 predecessor = 75.5 dB (a)
- Mafell FM-1000 - New model = 71 dB (A)
6 decibels reduced sound levels mean for the human ear in about half the volume
- model making, mold making, sign making, engraving, jewelry, electronics, stone carvings
- Ideal for portal milling machines, cutting tables, grinders and flexible shaft
- for wood, metal , plastics, foam, polystyrene, stone
rated input 1.000 W
nominal idling speed 4,000 ... 25,000 1 / min
Collar 43 mm
collet 8 mm
Dimensions LxHxW: 254 x 79 x 73 mm
Sound pressure level dB (A) = 71
network cable length 4 meters
weight 1.65 kg
- milling motor Mafell FM-1000 PV
- collet Ø 8 mm
- end wrench SW17
- operating instructions
the collet system Mafell compatible with the collet of Kress (1050 FME-1, 800 FME 800 FME-Q 530 FM, FS 6901, FS 6901 e). It is therefore possible to use your existing Kress collets further
More information can be found on the manufacturer's website:http://fm.mafell.de/